The mechanism sand production line is made up of sand making machine, jaw crusher, impact crusher, feeder, vibrating screen, and so on. Our production line has low operating cost, high crushing rate, energy saving, large output, less pollution, simple structure, easy installation, easy maintenance and small pollution.

We all know that the machine needs a certain period of running in. The newly purchased machine and equipment need new grinding in the process of processing and production, and then it can be used in our production and life. What are the problems that need to be paid attention to as the grinding machine used for sand and stone processing production?

The running in period of mechanical equipment also calls for the term of conformity, generally referring to the process of contacting, rubbing, and interlocking of mechanical parts at the initial stage of operation. During the running in period, it can adjust the capability of each component of the mechanical equipment to cooperate with the environment and wear out the uneven parts of the parts. The running in period of sand making machine is very important, and it is the key point that the sand making machine can operate normally in the later sand making process.

It is necessary to pay attention to the grinding of the sand making machine. Before the operation of the machine, please carefully read the instructions and operation manual of the machine, know the performance of the equipment, the empty load operation and the load operation. Under normal conditions, the air load is running for 4 hours, and the belt pulley should be checked when the load is running. The flexibility of the machine, the installation of the machine is firm, there is no other noise, etc., to check and adjust the loose parts in time to prevent the wear of parts caused by loosening.

The user also needs to pay attention to the working load of the grinding machine during the running in. The working load should not exceed 80% of the rated working load, so as to arrange the appropriate workload to prevent the heating of the machine because of the long work. In the running in period, the lubrication phenomenon of the equipment should be paid attention to, the lubrication is not good, and the scratch and bite of the precision parts will be caused. In case of running in, we should check the data of the instruments regularly to see if there is any abnormality.

Comments are closed.